Experimental Investigation of the Effect of Collector Profile, Tower Diameter and Tower Height on the Performance of Small-Scale Solar Updraft Power Generator

Hadyan Hafizh, Ahmad Fudholi, Abrar Ridwan

Abstract


The performance of a small-scale solar updraft power generator is experimentally investigated under the effects of collector profile, tower diameter and tower height. The updraft velocity and temperature are measured from a total of 36 experiment cases. The current study’s objective is investigating the optimum configuration that produces maximum updraft velocity and mechanical power output. The highest average updraft velocity of 1.22 m/s was recorded in experiment case number A-20. The highest average mechanical power of 12.35 mW is produced by experiment case number A-24. Both the collector height and tower diameter have optimum ranges that result in maximum updraft velocity and mechanical power. Increasing the collector height is bounded by heat losses in the collector and lowering the collector height is limited by the friction force where the airflow entrance is restricted. Having a larger tower diameter could have a negative effect on system performance. This situation was observed in experiment case number A-11 where increasing the tower diameter leads to a reduction of both updraft velocity and mechanical power. Since increasing the tower height always results in increased mechanical power, the collector height must be carefully matched with the tower diameter for a given tower height.

Keywords


solar energy; solar updraft; power generator; updraft velocity; mechanical power

Full Text:

PDF

References


A. B. Kasaeian, S. Molana, K. Rahmani, and D. Wen, “A review on solar chimney systems,” Renew. Sustain. Energy Rev., vol. 67, pp. 954–987, 2017.

P. Guo, T. Li, B. Xu, X. Xu, and J. Li, “Questions and current understanding about solar chimney power plant: A review,” Energy Convers. Manag., vol. 182, pp. 21–33, 2019.

R. Balijepalli, V. P. Chandramohan, and K. Kirankumar, “Optimized design and performance parameters for wind turbine blades of a solar updraft tower (SUT) plant using theories of Schmitz and aerodynamics forces,” Sustain. Energy Technol. Assessments, vol. 30, pp. 192–200, 2018.

M. Ghalamchi, A. Kasaeian, M. Ghalamchi, and A. H. Mirzahosseini, “An experimental study on the thermal performance of a solar chimney with different dimensional parameters,” Renew. Energy, vol. 91, pp. 477–483, 2016.

M. Aligholami, S. Sh. Khosroshahi, and A. R. Khosroshahi, “Hydrodynamic and thermodynamic enhancement of a solar chimney power plant,” Sol. Energy, vol. 191, pp. 180–192, 2019.

S. Jamali, M. Yari, and S. M. S. Mahmoudi, “Enhanced power generation through cooling a semi-transparent PV power plant with a solar chimney,” Energy Convers. Manag., vol. 175, pp. 227–235, 2018.

H. Nasraoui, Z. Driss, and H. Kchaou, “Novel collector design for enhancing the performance of solar chimney power plant,” Renew. Energy, vol. 145, pp. 1658–1671, 2020.

P. J. Cottam, P. Duffour, P. Lindstrand, and P. Fromme, “Effect of canopy profile on solar thermal chimney performance,” Sol. Energy, vol. 129, pp. 286–296, 2016.

X. Zhou, “Thermal performance of curved-slope solar collector,” Int. J. Heat Mass Transf., vol. 150, p. 119295, 2020.

X. Zhou, Y. Xu, S. Yuan, R. Chen, and B. Song, “Pressure and power potential of sloped-collector solar updraft tower power plant,” Int. J. Heat Mass Transf., 2014.

S. Hu, D. Y. C. Leung, and J. C. Y. Chan, “Impact of the geometry of divergent chimneys on the power output of a solar chimney power plant,” Energy, vol. 120, pp. 1–11, 2017.

Y. Xu and X. Zhou, “Performance of divergent-chimney solar power plants,” Sol. Energy, vol. 170, pp. 379–387, 2018.

S. Hu, D. Y. C. Leung, M. Z. Q. Chen, and J. C. Y. Chan, “Effect of guide wall on the potential of a solar chimney power plant,” Renew. Energy, vol. 96, pp. 209–219, 2016.

Ž. Penga, S. Nižeti?, and M. Ar?c?, “Solar plant with short diffuser concept: Further improvement of numerical model by included influence of guide vane topology on shape and stability of gravitational vortex,” J. Clean. Prod., vol. 212, pp. 353–361, 2019.

D. Eryener and H. Kuscu, “Hybrid transpired solar collector updraft tower,” Sol. Energy, vol. 159, pp. 561–571, 2018.

D. Eryener, J. Hollick, and H. Kuscu, “Thermal performance of a transpired solar collector updraft tower,” Energy Convers. Manag., vol. 142, pp. 286–295, 2017.

S. Kiwan, M. Al-Nimr, and I. Salim, “A hybrid solar chimney/photovoltaic thermal system for direct electric power production and water distillation,” Sustain. Energy Technol. Assessments, vol. 38, p. 100680, 2020.

A. Pratap Singh, A. Kumar, Akshayveer, and O. P. Singh, “Performance enhancement strategies of a hybrid solar chimney power plant integrated with photovoltaic panel,” Energy Convers. Manag., vol. 218, p. 113020, 2020.

H. H. Al-Kayiem, M. A. Aurybi, S. I. U. Gilani, A. A. Ismaeel, and S. T. Mohammad, “Performance evaluation of hybrid solar chimney for uninterrupted power generation,” Energy, vol. 166, pp. 490–505, 2019.

F. Cao, H. Li, Q. Ma, and L. Zhao, “Design and simulation of a geothermal-solar combined chimney power plant,” Energy Convers. Manag., vol. 84, pp. 186–195, 2014.

A. Habibollahzade, E. Houshfar, M. Ashjaee, A. Behzadi, E. Gholamian, and H. Mehdizadeh, “Enhanced power generation through integrated renewable energy plants: Solar chimney and waste-to-energy,” Energy Convers. Manag., vol. 166, pp. 48–63, 2018.

F. Attig-Bahar, M. Sahraoui, M. S. Guellouz, and S. Kaddeche, “Effect of the ground heat storage on solar chimney power plant performance in the South of Tunisia: Case of Tozeur,” Sol. Energy, vol. 193, pp. 545–555, 2019.

A. A. Sedighi, Z. Deldoost, and B. M. Karambasti, “Effect of thermal energy storage layer porosity on performance of solar chimney power plant considering turbine pressure drop,” Energy, vol. 194, p. 116859, 2020.

Y. Amudam and V. P. Chandramohan, “Influence of thermal energy storage system on flow and performance parameters of solar updraft tower power plant: A three-dimensional numerical analysis,” J. Clean. Prod., vol. 207, pp. 136–152, 2019.

C. Méndez and Y. Bicer, “Integration of solar chimney with desalination for sustainable water production: A thermodynamic assessment,” Case Stud. Therm. Eng., vol. 21, p. 100687, 2020.

C. B. Maia, F. V. M. Silva, V. L. C. Oliveira, and L. L. Kazmerski, “An overview of the use of solar chimneys for desalination,” Sol. Energy, vol. 183, pp. 83–95, 2019.

R. Balijepalli, V. P. Chandramohan, and K. Kirankumar, “Development of a small scale plant for a solar chimney power plant (SCPP): A detailed fabrication procedure, experiments and performance parameters evaluation,” Renew. Energy, vol. 148, pp. 247–260, 2020.

R. Balijepalli, V. P. Chandramohan, and K. Kirankumar, “Performance parameter evaluation, materials selection, solar radiation with energy losses, energy storage and turbine design procedure for a pilot scale solar updraft tower,” Energy Convers. Manag., vol. 150, pp. 451–462, 2017.

A. Hassan, M. Ali, and A. Waqas, “Numerical investigation on performance of solar chimney power plant by varying collector slope and chimney diverging angle,” Energy, vol. 142, pp. 411–425, 2018.

Joint Committee for Guides in Metrology, “Evaluation of measurement data — Guide to the expression of uncertainty in measurement,” Int. Organ. Stand. Geneva ISBN, vol. 50, p. 134, 2008.

H. Hafizh and H. Shirato, “Aerothermal simulation and power potential of a solar updraft power plant,” vol. 61A, pp. 388-399, 2015.

A. Ayadi, A. Bouabidi, Z. Driss, and M. S. Abid, “Experimental and numerical analysis of the collector roof height effect on the solar chimney performance,” Renew. Energy, vol. 115, pp. 649–662, 2018.

O. B. E. Mokrani, M. H. Sellami, M. R. Ouahrani, and L. Segni, “Experimental Investigation on the effects of opening areas on solar chimney performance,” Proc. - Int. Conf. Commun. Electr. Eng. ICCEE 2018, pp. 1–5, 2019.

D. Toghraie, A. Karami, M. Afrand, and A. Karimipour, “Effects of geometric parameters on the performance of solar chimney power plants,” Energy, vol. 162, pp. 1052–1061, 2018.

R. Mehdipour, S. Golzardi, and Z. Baniamerian, “Experimental justification of poor thermal and flow performance of solar chimney by an innovative indoor experimental setup,” Renew. Energy, vol. 157, pp. 1089–1101, 2020.

E. Cuce, H. Sen, and P. M. Cuce, “Numerical performance modelling of solar chimney power plants: Influence of chimney height for a pilot plant in Manzanares, Spain,” Sustain. Energy Technol. Assessments, vol. 39, p. 100704, 2020.

P. J. Cottam, P. Duffour, P. Lindstrand, and P. Fromme, “Solar chimney power plants – Dimension matching for optimum performance,” Energy Convers. Manag., vol. 194, pp. 112–123, 2019.




DOI (PDF): https://doi.org/10.20508/ijrer.v11i1.11778.g8140

Refbacks

  • There are currently no refbacks.


Online ISSN: 1309-0127

Publisher: Gazi University

IJRER is cited in SCOPUS, EBSCO, WEB of SCIENCE (Clarivate Analytics);

IJRER has been cited in Emerging Sources Citation Index from 2016 in web of science.

WEB of SCIENCE between 2020-2022; 

h=30,

Average citation per item=5.73

Impact Factor=(1638+1731+1808)/(189+170+221)=9.24

Category Quartile:Q4